Wavetek 147 Spezifikationen PDF herunterladen (Seite 49)

Description and Basic Operation: Configuring the SDA-5000

The required serial printer configuration is as follows:

• Baud rate consistent with SDA-5000 Receiver (9600 or 19.2K

recommended)

• 8 data bits

• 1 stop bit

• No parity

• Flow control - hardware handshaking

Printing to a parallel printer requires a serial-to-parallel converter such as

the one manufactured by Black Box Corp. (Phone 412-746-5500). The

setup is the same as the serial printer configuration.

• Lines/Page: Use this option to specify the number of lines per page

(min 30, max 255) for text printouts. This determines the number of lines

printed before a form feed command is sent. For no form feeds, enter

zero (0) here.

• Baud Rate: The baud or bit rate establishes the speed of

communications between the SDA-5000 receiver and another device.

Baud values available are 1200, 2400, 4800, 9600, and 19.2k.

• Beeps: Use the diamond keys to turn on or off key-press clicks and

instrument beep functions.

• Splash Screen: Use this option to enable or disable the splash screen

that appears when you turn on the unit.

• Diagnostics: To enter Diagnostics mode, highlight this option and press

the Enter key.

See Also

½ The “Diagnostics” section later in this chapter covers

diagnostics configuration in detail (page 29).

Measurements Configuration (Including QAM OPT4)

When you select MEASUREMENT from the CONFIGURE menu shown in

Fig. 2-6, you’ll see options for adjusting seven variables. If you have the

QAM option (OPT4), you will see an additional four items, as described

below (see Figure 2.8). Use the up and down arrow keys to scroll through

the list, and change the variables as indicated in the Edit Box.

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 409 410

Keine Kommentare

Wavetek 147 Spezifikationen Seite 49