Wavetek 39A Spezifikationen PDF herunterladen (Seite 46)

User Manual 301/302

Figure 3.11 below. Each filter may be switched by checking the

relevant box. The filters can be applied to the main or auxiliary

channel output by clicking the diamond shaped button alongside the

relevant selection.

Figure 3.11 Adjusting Filter Parameters

Selecting an

Operating Mode

The Model 301/302 offers four operating modes: Continuous,

Triggered, Gated and Burst. The selected waveform is repeated

continuously when the instrument is set to operate in Continuous

mode. In this mode, the Model 301/302 does not require a trigger

source to stimulate output cycles. The default operating mode of the

instrument is continuous.

Triggered, Gated, and Burst modes require an external signal to

initiate output cycles. Information on how to trigger, gate or output a

burst of waveforms is given in the following paragraphs. The WaveWiz

Trigger control panel (Figure 3.12 below) shows an example of

selecting the trigger mode.

Trigger slope and level, speed of the internal trigger generator, count

(for bursts) and trigger source are all set on the trigger tab of the

control panel. The

button allows a user to manually trigger

the generator.

Configuring the Instrument

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 136 137

Keine Kommentare

Wavetek 39A Spezifikationen Seite 46