Wavetek 39A Spezifikationen PDF herunterladen (Seite 74)

User Manual 301/302

of Sequences

The active sequence is set by entering the number in the Active

Sequence box.

For a discussion on implications of numbers of sequences, see earlier

section describing commands for sequences.

Figure 3.23 Selecting number of sequences to be used

Selecting active

Sequence

Use the sequence button on the sequence tab in the Instrument

Control Panel. The sequence table pop-up menu appears. The active

sequence is set by entering the number in the Active Sequence box.

To Enter Sequences, use the data entry box marked within the

sequence table. “Link” is the numeric position of that particular step in

the sequence; Loop is the number of times that link will repeat before

moving on to the next link in the sequence. Segment is the number of

the waveform segment that should be outputted while that link is

executing. As an example the following sequence

Link# Loop(s) Segment #

1 1 1

2 8 4

3 2 2

Will result in an output consisting of segment 1 repeated once, then

segment 4 repeated 8 times followed by segment 2 twice.

To add or delete links, click on the append or delete buttons.

Configuring the Instrument

1 2 ... 69 70 71 72 73 74 75 76 77 78 79 ... 136 137

Keine Kommentare

Wavetek 39A Spezifikationen Seite 74